ES-20
Electrical System Argo Service Manual
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
12. Set clock. Push Select button
13. Set display brightness between 5-1 to 5-5. Push Select button.
14. Exit the setup by turning the key o.
Calibrating the Digital Gauge Package
Frontier Digital Gauge Package
1. With key switch o, hold both “Select” and “Adjust” buttons down simultaneously.
2. Turn the key to the run position until you see the letter “adj” and then release both but-
tons.
3. Using the “Adjust” button, change the "P-" number to 4 (tach setting). Push the Select
button.
4. Using the “Adjust” button, change the top ashing numbers to read 1914 (for 24"tires).
Cycle to the next number using the “Select” button.
5. Set the lower number to 15P (speedometer setting) using the Adjust button. Push the
Select button.
To Next Page
Loading...
