EasyManua.ls Logo

Argo All 8X8 - General Instructions

Argo All 8X8
297 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ES-3
Electrical System Argo Service Manual
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
General Instructions
WARNING
Detailed information on standard workshop and safety procedures, and general servicing
operations is not included in this manual, which has been prepared to assist qualied
service personnel. ARGO assumes no responsibility or liability for PERSONAL INJURY
or VEHICLE DAMAGE which results from any servicing procedure performed, including
those instructions outlined in this manual. Before performing a servicing operation, an
individual must have determined to his/her satisfaction that a personal injury or vehicle
damage will not result from the servicing procedure or tools selected.
CAUTION
To prevent damage to the electrical system:
Always disconnect the battery when servicing any electrical component.
Never weld on the vehicle without rst disconnecting both positive and negative
battery cables. Make sure the part you are welding is properly grounded.
Connecting booster cables to start your vehicle is not a recommended practice.
Damage to engine electrical components could occur.
Connect switch terminals properly, especially the ground wire.
WARNING
Battery uid contains sulphuric acid. If battery uid comes in contact with skin or
eyes, ush thoroughly with water. If swallowed, call physician or poison control
centre immediately. KEEP AWAY FROM CHILDREN. Serious personal injury
can occur. Always wear rubber gloves and safety glasses when servicing the battery.
Batteries can explode and cause serious personal injury if exposed to ame or
sparks. Never smoke while servicing the battery.
ES INDEX
MAIN INDEX

Table of Contents