Argo All 8X8 - Checking the Hydraulic Brake Fluid Level (Steering Brakes

Brake System Argo Service Manual
BR-4
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Maintenance Schedule
Every 25 hours of vehicle operation Perform the servicing procedure, Brake
Pad Inspection.
Every 50 hours of vehicle operation Perform the servicing procedure, Inspect Brake
Fluid Level/Condition.
NOTE
The intervals shown in the Argo Maintenance Schedule Chart (found in the General In-
formation section of this service manual) are based on average operating conditions.
Vehicles which are subject to more severe use, wet or dusty conditions, will require more
frequent servicing.
NOTE
Please refer to the appropriate illustrated parts manual for the vehicle being serviced.
The parts manual is identied with either the vehicle’s model number, serial number or
both written on the front cover.
Hydraulic Brakes
General
Although the hydraulic brake system is self adjusting, the following require periodic
attention:
Brake Fluid Level (Steering Brake Master Cylinders)
After every 50 hours of operation, check the brake uid level by removing the master
cylinder covers.
Brake Fluid Level (Service Brake Master Cylinders) Aurora Models Only
After every 50 hours of operation, check the brake uid level by removing the master
cylinder covers.
Checking The Hydraulic Brake Fluid Level (Steering Brakes ), Aurora and Frontier
600 EU Models Only
IMPORTANT
Thoroughly clean the master cylinder cover and surrounding area before removal.
1. Locate the steering master cylinders in the engine compartment near the rewall at
the steering column. When adding uid, ll to mark on reservoir.
BR INDEX
MAIN INDEX