Transmission Argo Service Manual
TR-14
7. Remove the Retaining Ring that secures the second Sun Gear to the Output Shaft on
the Gear Plate side. See following page.
8. Slip the Sun Gear from the Output Shaft Gear Plate side.
9. Press the Output Shafts from both Cage and Gear Plate.
10. Remove each of the 101-15 Bearings from both Cage and Gear Plate. Using the 608-
54 Bearing Removal Tool, remove each bearing from both Gear Plate and the Alumi-
num Cage. Tap with a soft faced mallet. See following page.
To Next Page