General Information Argo Service Manual
GI-20
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
SPECIALIZED TOOLS
A pair of modied 7R Vice Grips is required
to hold the ends of the drive chain together
while inserting the connecting link. This tool
can also be used to hold the ends of the idler
chain together while inserting the connecting
link. Grind the undercut and sides of the
vice grip jaw to t over 2 chain rollers. The
undercut is approximately 1/4" radius.
1. 608-54 Bearing Removal Tool
2. 658-05 Needle Bearing Remover/Installer
3. 658-06 Output Shaft Puller
4. 658-07 Bearing Installer (101-15 Bearing)
5. 658-16 Right Angle Grease Fitting
6. 638-02 Oil Change Pump
7. 19352 Tang Bending Tool
7. 193889 Tiny Tach
8. 19545 Leak Down Tester - Briggs (can be
used for all engines)
9. 619-10 Low Pressure Tire Gauge
10. 19626 Briggs Tiny Scan Code Reader
11. 19628 Briggs Diagnostic Software and Inter-
face Cable
12. 19624 Briggs Big Block Fuel Pressure
Test Adapter
13. 19623 Briggs Noid Light (EFI)
14. 19627 Briggs Fuel Pressure Gauge
15. ST 270 12270 Cooling System Pressure
Testing Kit (Available local Auto Parts)
16. 19625 Briggs Back Probe Wire Set
17. 19368 Briggs Spark Tester
18. 25 761 50 Kohler Diagnostic Software
19. 847252 EFI Diagnostic power harness
20. 5055- 0002 Clutch Assembly/Disassembly Tool
1
2
3
4
To Next Page