Temperature at limit.
Fan RPM raised
With camera fan is in "Rec low" mode, fan
noise might exceed silent level because
camera is becoming too hot.
Master/slave: Focus
unit mismatch
With ALEXA Plus and 3D lens sync, both
cameras must have same focus unit
activated, which is not the case here.
Slave: No lens table
active.
With ALEXA Plus and 3D lens sync, select
lens table on slave when using LDA.
Sensor in High
Humidity mode
Reminder for active High Humidity mode
ND filter stuck ALEXA Studio only.
ND filter slider has mechanical problems.
Mirror sector
problem
ALEXA Studio only.
Mirror sector has mechanical problems.
Mirror cannot reach
sync speed
ALEXA Studio only.
Mirror cannot reach speed due to technical
problems.
Voltage too low for
mirror
ALEXA Studio only.
Power supply voltage level insufficient to
drive mirror shutter.
Mirror out of phase ALEXA Studio only.
Mirror shutter and sensor are out of phase,
may result in exposure artifacts.
Mirror failure. Press
GATE or VIEW.
ALEXA Studio only.
Mirror shutter initialization failed, press
GATE or VIEW to reset mirror shutter
manually.
Some buttons are
defect
Camera button signals are failing. Reboot
camera. If reappearing after reboot, contact
service for button replacement. Mostly
hardware problem.
SxS/Media: Data rate
low. Check last clip.
Data rate of last recorded clip is very low.
Check for artifacts in replay. Can also occure
when forgetting to remove lens cap during
recording.
Loading highspeed
mode
While High Speed Mode is loading, the
camera functionality is limited. Wait until
High Speed mode loading has finished.
LDS failure. Reboot. The lens data system has failed. Restart the
camera if LDS is used.
M head: Clean fibre
connection.
The fibre signal quality of the ALEXA M
camera is insufficient and requires cleaning
of the connections.
To Next Page
Loading...
Need help?
General
