Synced camera is not ready One of the slave cameras is not
ready for recording.
Software error. Reboot. A part of the camera software
has stopped functioning
properly and requires a camera
reboot.
Internal audio recording failed Audio recording on internal
medium failed.
REC OUT: Frame drops. Set fps. Frame rate of REC OUT is
smaller than sensor fps. Make
sure REC OUT frame rate
matches sensor fps.
Dual recording failed. Check
cards.
With dual recording active, the
two SxS PRO cards must have
identical file structure. Use two
fresh SxS PRO cards and
analyze the not matching ones.
REC OUT: Frame drops. Set FPS. SxS is switched off, and sensor
fps is higher than REC OUT fps.
Increase REC OUT fps to at least
the sensor fps value.
REC error. Reboot. Error in the recording module.
Reboot camera.
Mirror shutter not calibrated ALEXA Studio only.
Mirror shutter must be
calibrated by ARRI service.
Mirror shutter phase error ALEXA Studio only.
Mirror shutter continuosly not in
phase with sensor. If rebooting
does not solve the problem,
contact ARRI service.
Mirror shutter: Cannot reach
sync speed
ALEXA Studio only.
Mirror shutter continuosly not
reaching sync speed. If
rebooting does not solve the
problem, contact ARRI service.
No M head detected. Reboot. ALEXA M was booted without
head connected. Connect head
and reboot camera.
Fibre Connection Error Fibre connection between
ALEXA M head and backend
could not be established or has
terminated. Check and clean
connection, then reboot.
M head: Low power The power level of the ALEXA M
head is critical. Make sure power
supply can deliver at least 40 W
of power. Check if power
warning levels are set correctly.
To Next Page
Loading...
Need help?
General
