108
Converting the Bridge Plate
to Super 35
The current position, standard or Super 35, is displayed by
two index arrows on the sliding upper plate. The bridge
plate can be converted to Super 35 as follows:
• Remove the two screws ➪ photo.
• Turn the compensation bar 180° and screw tightly in
this position.
Note: The viewfinder system is so designed that no
alteration is necessary for shooting in Super 35.
For instructions on inserting format masks into the film gate
for Super 35, see
Chapter 7, Camera Body, Film Gate
.
Regarding illuminated format markings for this format,
see
Chapter 8, Optics, Viewfinder System, ARRIGLOW
.
Super 35
index arrows
screws
To Next Page
Loading...
Need help?
General