42
Attaching the Magazine,
Threading the Movement
• Pull the magazine release lever ➪ photo back and
remove the cover.
• Open the camera door.
• Check that the movement block is swung forwards.
• Remove the loop protector from the magazine.
When attaching the magazine, pay attention
that the film does not get caught between the
magazine and the dovetail on the camera
opening!
• Position the back part of the magazine’s throat assembly
on the lower dovetail of the camera opening.
• With your left hand pull the film loop through the camera
opening as far as possible into the movement block area
➪ photo.
• Before locking the magazine into place, ensure that the
film is pulled far enough into the movement block area so
that the film does not get caught between the magazine
and the magazine locking mechanism!
Camera Body
magazine
release lever
film
To Next Page
Loading...
Need help?
General