31
• Close the magazine cover. The roller arms will be auto-
matically unlocked.
• To lock the cover, turn the locking grip clockwise and flip
it back into the recess.
The safety catch locks automatically.
Note: To tension the film in the magazine, press in
both tensioning plates ➪ photo and turn out-
wards.
Removing Exposed Film
The following steps should be carried out in a darkroom or
a changing bag!
• Check if the entire film has been wound into the interior
of the magazine. If not, transport the film into the magazine
by turning the drive gear counter-clockwise.
• To open the cover, depress the safety catch and flip the
locking grip upwards. Then turn the grip counter-clock-
wise.
• Flip up the cover.
• Swing both roller arms ➪ photo away from the winding
shafts until they lock in place.
• Flip up the hinged locking clip on the take-up shaft.
• Pull the film roll upwards and off.
Note: When pulling the film roll off the shaft, grip it
from underneath as far as possible to prevent
the middle of the film roll from sagging down.
The film should under no circumstances be
pulled tight. This could cause scratches and
static charging.
Magazines
tensioning plates
To Next Page
Loading...
Need help?
General