83
Heated Eyecup HE-3
The heated eyecup prevents the eyepiece ➪ photo from
fogging in low temperatures e.g. when filming outdoors
in winter.
• Pull the normal eyecup off the eyepiece, then place the
heated eyecup on the eyepiece.
• Plug the heated eyecup either
with cable KC-26S to the 11-pin accessory socket, or
with cable KC-42S to the RS-socket.
• Set the heating level with the toggle switch ➪ photo:
“LO”: low heat output
“HI”: higher heat output.
If the camera and accessories are powered by
battery, it is recommended to switch off the
eyecup-heating during extended breaks in filming.
Remote Run Switch RS-4
• Attach the remote run switch with the spring clamp
➪ photo (e.g. to the pan handle).
• Plug the RS-4 plug into the “RS”-socket.
Accessories
To Next Page
Loading...
Need help?
General