56
Running and Stopping the Camera
A “RUN”-button is located on the left side of the camera
➪ photo.
Running the Camera
If the operation control indicator glows red
while in standby, the camera is not ready and
will not run
(see “Overview of Display Symbols”).
• Briefly depress the “RUN”-button. While the camera is
running up, the operation control indicator ➪ photo
glows red. Once the set frame rate has been reached,
the operation control indicator turns green.
Stopping the Camera
• Again depress the “RUN”-button ➪ photo briefly.
While the camera is running down the operation control
indicator glows red. The mirror shutter automatically stops
in a position that enables unrestricted viewing through
the viewfinder. On reaching this position, the operation
control indicator flashes green before going out.
Camera Operation
operation control
indicator
„RUN“-button
“PHASE”-button“MODE”-button
“LOCK” sliding
switch
To Next Page
Loading...
Need help?
General