27
6. Magazines
In addition to the new 435-ARRIMAG magazines ➪ photo,
all ARRIFLEX 35 III and 35 II magazines – with the exception
of the shoulder magazine – can be used.
Magazine Speed limit Forward/Reverse operation TC-Recording Motion Control Support
ARRIFLEX 435
ARRIMAG 120 150 fps forw./rev. yes yes
ARRIMAG 120S 150 fps forw./rev. yes yes
ARRIMAG 300E 150 fps forw./rev. yes fwd only (rewind possible)
ARRIFLEX 35 III / 35 II
60 m magazine 130 fps only forwards no fwd only (do not rewind)
150 m magazine 130 fps forw./rev. no yes
300 m magazine 130 fps only forwards no no
Reverse operation with the ARRIFLEX 35 III / 35 II
300 m and 60 m magazines can lead to damage
of the magazine or the camera!
Time code can only be recorded with the new
ARRIMAG magazines.
When the camera is set to reverse running and
the old style 300m magazine is attached, the
camera will display ‘dir Error dIr‘ in the display.
The ARRIMAG magazines and the ARRIFLEX III magazines
are automatically recognized. For the ARRIFLEX 35 III 300 m
magazine the camera’s run-up time is automatically exten-
ded. If the camera is set to a frame rate that exceeds the
speed limit of the attached magazine, the “fps“-symbol
flashes on the camera display and the camera will not run.
If the frame rate is adjusted above the magazine speed
limit during running, the camera´s speed will be limited to
130 fps. The frame rate must be reset.
Note: All magazines listed below are loaded with the
same loop length as on the ARRIFLEX 35 III.
The loading of ARRIFLEX 35 III magazines is
described in the respective instruction manuals.
Magazines
To Next Page
Loading...
Need help?
General