131
15. Appendix
The frame rate of the camera is constantly monitored while
it is running. If the actual frame rate deviates from the set
frame rate, the operation control indicator glows red and
the camera display shows the warning for asynchronous
running (“asy”).
The synchronization of the shutter and the movement is also
monitored. Should an undue deviation in the synchronization
occur, the camera will stop. The display will show “asy”.
This monitor function is built into the electronic control of
the drive system.
As an additional security feature for the user, a second, in-
dependently operating monitor system for the shutter/move-
ment synchronization is integrated into the camera electronics.
If this additional circuit stops working while the camera is
running, the display will show a warning after the camera
is stopped. The operation control indicator will remain red,
the camera cannot be re-started and must be checked by
an ARRI service center.
This display only indicates that the additional monitor
system is defective.
Appendix
If the warning “Monitoring Defective” is over-
ridden, an additional fault in the electronic control
of the drive system will not be detected and may
cause faulty exposure!
If the display reads “SUPLY Error” the battery
voltage is extremely low and the processor of
the camera halted execution of the camera
software.
If the display reads “Intxx Error”, switch the
camera off and on to reset it. This is a internal
software error message that a unexpected state
occured. xx stands for a two digit number that
will be displayed in this position
To Next Page
Loading...
Need help?
General