85
Ensure that the fastening flaps are properly po-
sitioned in the camera housing before swinging
the FEM into place, otherwise they may catch
and be damaged!
• Swing the functional expansion module onto the camera
housing.
• Screw tight the fastening screw ➪ photo on the functional
expansion module.
External Synchronization Unit ESU-1
The use of the ESU-1 ➪ photo is only possible with the
function expansion module attached to the camera. The
external synchronization unit ESU-1 can be used with the
ARRIFLEX 435 Advanced as well as with the 435/435ES,
535, 535B and 16SR 3/Advanced. It allows synchronization
of the camera to other equipment such as TV monitors. By
means of a BNC-socket, it is possible to synchronize to an
external standard video signal (50/60 Hz) or, through an
inductive pickup, to a computer or video monitor. The
camera display shows “ESU” in the upper line. The ESU-1
can be used for frame rates from 3 to 60 fps.
Note: The ARRIFLEX 435/435ES can additionally be
synchronized within a frame rate range of 3 to
150 fps. An appropriate cable is available on
request.
The frame rate is indicated on the camera display in Mode 2.
A phase shifter and a pilottone generator have also been
integrated into the external synchronization unit. The synchro-
nization is retained even when the camera is switched off.
See TECHN. INFORMATION “External Synchronization
Unit ESU-1”.
Accessories
To Next Page
Loading...
Need help?
General