35
Shutter Angle Measurement
• Holding the “PHASE”-button depressed in standby will
make the camera inch forward.
• The display shows the measured shutter angle in the
upper line. The lower line displays the voltage of the
power supply.
Switching Off
the Electronically Adjustable Shutter
• Switch on the camera’s main switch.
• Change to Mode 7 by depressing the “MODE”-button six
times (or four times if no functional expansion module is
attached). The display shows the angle symbol and, in the
upper line, the current shutter angle.
• Depress the “SEL”-button repeatedly until the display shows
“OFF”. With the “SET”-button, confirm switching off the
electronic angle adjustment.
As the electronic shutter has been switched off,
the shutter angle must now be adjusted and locked
manually! See the section “Mechanically Ad-
justable Mirror Shutter”.
Note: As a warning that the electronic shutter has been
switched off, the angle symbol in the camera
display blinks in all modes.
Switching On
the Electronically Adjustable Shutter
Switching on the electronically adjustable shutter
when the shutter is locked can cause damage to
the camera! See “Checking the Shutter Locking
Mechanism”.
• Before switching on, ensure that the shutter locking
mechanism is in “LOOSE” position.
• Switch on the camera’s main switch.
• Change into Mode 7 by depressing the “MODE”-button
six times (or four times if no functional expansion module
is attached). The display shows the angle symbol and
“OFF” in the upper line.
• Depress the “SEL”-button repeatedly until the display shows
the desired shutter angle. The “SET”-button confirms the
entry and activates the electronic shutter adjustment.
Camera Body
To Next Page
Loading...
Need help?
General