98
Activating and Running Programs
Note: If the “PROG”-button on the camera is not
accessible, the “F4”-key in the REMOTE menu on
the CCU-1 can be used as a “PROG”-button.
• Set the NORM/PS switch on the camera to “PS/CCU”.
• Activate the program mode with the “PROG”-button
on the left side of the camera (the indication “Pr” appears
in the camera display).
• Start the camera. The camera runs at the starting
frame rate and the corresponding shutter angle.
• Depress the “PROG”-button.
The camera changes its frame rate and the shutter angle
in the programmed time to the end frame rate and
end shutter angle.
• By again depressing the “PROG”-button the frame
rate and shutter angle will return to their starting
values simultaneously.
Note: If the camera is set to rampspeed HI the total
duration of the ramp will be minimized. Check
Mode 7 for recalculated duration.
Note: To prevent an unintentional alteration the function of
“PROG” button can be locked using the sliding
switch “LOCK”. However this locking does not
affect connected accessories such as the CCU-1.
Note: The program itself is stored in the camera and
therefore can also be activated if the CCU is not
plugged in. As soon as a program is activated,
accessories connected to the “ACC” socket will no
longer control the camera. At the same time, it is
no longer possible to send a new program from
the CCU to the camera. Furthermore, the RCU-1
can only be used in the “CAM” Mode.
Accessories
To Next Page
Loading...
Need help?
General