ARRI TRINITY 2 - Page 20

About the product 20
EN IEC 62368-1:2020 + A11:2020
EN IEC 63000:2018
The object of the declaration described above complies with the provisions of Directive 2011/65/EU
of the European Parliament and the Council of June 8, 2011 on the restriction of the use of certain
hazardous substances in electrical and electronic equipment and the Commission Delegated Directive
(EU) 2015/863 of March 31, 2015.
The manufacturer bears sole responsibility for issuing this declaration of conformity.
UK Declaration of Conformity
Brand Name:
Product Description:
ARRI
Camera Stabilizer SystemTRINITY 2
The designated products conform to the specifications of the following United Kingdom regulations:
The Electromagnetic Compatibility Regulations 2016 (SI 2016 No. 1091 as amended by SI 2019
No. 696)
The Electrical Equipment (Safety) Regulations 2016 (SI 2017 No. 1206 as amended by SI 2019 No.
696)
The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012 (SI 2012 No. 3032 as amended by SI 2020 No. 1647 SI 2021 No. 422 and SI
2019 No. 492)
The compliance with the requirements of the United Kingdom regulations was proved by the
application of the following standards:
EN55032:2015
EN55035:2017
EN61000-4-2:2009
EN61000-4-3:02006 A1 2008 A2:2010
EN61000-4-8:2010
EN50581:212
The manufacturer bears sole responsibility for issuing this declaration of conformity.
FCC Compliance Statement
Class A Statement: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Changes or modifications to the product not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Industry Canada Compliance Statement
Complies with the Canadian ICES-003 Class A specifications.