Setup
DualWave Arthroscopy Pump User’s Guide
DFU-0212 Rev. 1 Page 26 of 54
7. Verify the status of the AR-6480 displayed in the operator display [5].
8. Connect the tubing in accordance with section 4.8 or 4.9
9. Close the roller housing doors.
10. Attach the remote control unit or foot pedal unit [4], if applicable.
11. Refer to section 5.0, Operation, for specific information on how to
operate the AR-6480, including pressure and flow settings.
12. Press the Run/Stop button [Table 3 or VI] to activate the pump motor.
WARNING!
DO NOT stack or place equipment adjacent to the AR-6480 console if possible. If
such a configuration is necessary, carefully observe the configuration in question
to ensure that electromagnetic interference does not degrade performance.
Do not attach the remote control or the foot pedal during the Self
Test or Programming Modes.
WARNING!
Use ONLY Arthrex approved accessories. Other accessories may result in
increased emissions or decreased immunity of the system. Contact your Arthrex
representative for a complete list of accessories. DO NOT modify any accessory.
Failure to comply may result in injury to the patient and/or operating room staff.
WARNING!
Do not use in the presence of flammable anesthetics or oxidizing gases such as
nitrous oxide, oxygen, or endogenous gases. All oxygen connections must be leak
free for the duration of the surgical procedure.
WARNING!
Use ONLY Arthrex approved tubing accessories. Other accessories may result in
decreased pressure accuracy. Contact your Arthrex representative for a complete
list of accessories. DO NOT modify any accessory. Failure to comply may result in
patient and/or operating room staff injury.
To Next Page
Loading...
Need help?
General
