CONFIGURATION MANUAL
Ascom d83 DECT Handset
Handset Configuration
• Message alert
Determines the message sound for incoming messages. A predefined melody (Message 1 - Message 7)
or a beep code that represents a certain sound can be selected. For more information about how to
configure sounds with beep codes, see 5.33.1 Configure Message Alerts with Beep Codes, page 45.
• Message alert during call
Determines if a message alert should be played when receiving a message during a call.
• Message volume
Determines the message volume for incoming messages. By default, the message volume is the same as
the volume of the ring signal. A different message volume can be set with this parameter. The parameter
may also be set to Silent to mute the message volume completely.
• Vibrator for call waiting
Determines whether or not the handset vibrates when another call is received before the user has
finished an ongoing call. If set to Yes, the handset vibrates during the ongoing call.
To enable the Vibrator for call waiting function the Vibrating alert parameter must be enabled,
and both Switch call and Call waiting must be configured. For more information about how to
configure Switch call and Call waiting, see 5.9 In Call Menu, page 19.
• Vibrator for message during call
Determines if the handset vibrates when receiving messages during an ongoing call.
The following options are available:
− Never activated: vibration is disabled for all incoming messages during a call.
− Only for urgent messages: the handset vibrates only when the received message is urgent.
− For messages with priority higher than low: vibration is disabled for all low priority messages during
a call.
− Always activated: the handset vibrates when receiving messages during a call.
To enable the Vibrator for message during call function the Vibrating alert parameter must be enabled.
Vibrator for message during call is overridden by the settings of Vibrating alert setting.
Regardless of the Vibrator for message during call configuration, the handset does not vibrate
to indicate new messages during a call when Vibrating alert is set to one of the following
options:
— On if silent
— Off
Settings → Messaging
• Text size
Size of the message text when viewing and writing messages.
• Time to Read (TTR)
Determines if the user needs to close a message manually, or if the message closes automatically when
TTR expires. Regardless how a message is closed, it is removed from the message queue and stored in
the Messaging Inbox. TTR starts when a message is displayed and keep running also when the message
is placed in the messaging queue. If a user presses any key when a message is displayed, the TTR is
reset. See also 5.33.3 Broadcast and Multicast Messaging, page 50.
TD 93426EN / 28 January 2022 / Ver. C
43
To Next Page
Loading...
Need help?
General
