Need help?Do you have a question about the ASCOM IP-DECT Base Station and is the answer not in the manual?
General| Type | IP-DECT Base Station |
|---|---|
| Technology | DECT |
| Connectivity | Ethernet |
| Number of DECT Handsets | Up to 8 |
| Range | Up to 300 meters outdoors, 50 meters indoors |
| Number of simultaneous calls | Up to 8 |
| Frequency Band | 1880-1900 MHz |
| Channels | 10 |
| Power Supply | PoE (Power over Ethernet) |
| Protocols | SIP |
| Interface | 10/100 Ethernet |
Defines technical terms like DECT, DHCP, IP, LAN, LDAP, PBX, RFP, VLAN.
Describes the IPBS, including versions with internal and external antennas.
Describes the IPBL, its versions, overview, power supply, and LED indication.
Describes the BS3x0 base station, its versions, overview, and power distribution.
General safety rules and precautions for using the IP-DECT system.
Details the risks of ESD and how to protect equipment.
Lists relevant US standards and regulations for the IP-DECT system.
Details the recommended base station cable (CAT5) and RJ45 connectors.
Describes how to mount the base station vertically or horizontally.
Lists the different ways to power the base station.
General instructions and important notes for installing the IPBL.
Explains the power supply options for the IPBL.
Explains how to access the graphical user interface for configuration.
Steps to configure the IPBS/IPBL as the master device.
Steps to configure IPBS/IPBLs as slave devices.
Describes how to add users and register handsets to the system.
Covers general configurations like renaming, licensing, and updates.
Configuration options for the Local Area Network settings.
Configuration settings related to the DECT system.
Provides an overview of connected devices and their status.
How to download and save the IPBS/IPBL configuration.
How to update configuration, firmware, boot file, and RFPs.
Provides diagnostic tools like logging, tracing, and ping.
How to perform an idle or immediate reset of the devices.
Tests to verify radio coverage and base station operation.
How to load firmware using the Gwload tool when web GUI is unreachable.
How to configure IPBS/IPBLs for automatic updates.
How to set UPO parameters for firmware updates.
RFP power consumption data for KRCNB 201/DCT1800.
To Next Page
