TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
13
Note: Ensure that during the installation of an base station, each base station is given an
extra length (5-10 metres) of cable because it is possible that it will have to be moved for
one reason or another.
4.2 Install the Base Station
The base station can be mounted vertically or horizontally. Mount the base station at
places and positions as determined in the base station plan, see Considerations for Ascom
IP-DECT System Planning, TD92422. The base station must be placed in a way that it is not
facing large metal objects such as large heating pipes.
4.2.1 Fix the Mounting Bracket to a Wall
Fix the mounting bracket (see figure 4 on page 14) to the wall as follows:
1 Hold the mounting bracket with its flat side against the wall with the text ‘TOP’
upwards and mark the two holes. The minimum distance between the upper hole
and the ceiling or any object above the base station must be at least 65 mm, see
figure 4. If the distance is less than 65 mm, the base station cannot be slid onto the
bracket.
2 When using wall plugs: Drill the two holes using a ∅ 6 mm drill and insert the
included wall plugs.
3 Position the mounting bracket with its flat side to the wall and fasten it with the
two included ∅ 3.5 mm screws.
To Next Page
Loading...
Need help?
General
