ASCOM IP-DECT Base Station User Manual

TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
42
3 Enter a new password in the Password text field. Repeat the password.
4 Click "OK".
7.5.2 Configure Authentication Code
If allow anonymous subscription method is selected it is needed for the IP-DECT system to
have an authentication code configured, select a code consisting of 4 to 8 numbers (0-9).
1 Select DECT > System.
2 Enter an authentication code in the Authentication Code text field.
3 Click "OK".
7.5.3 Change Subscription Method
The IP-DECT system can be set to use the following subscription methods:
• With User AC
•With System AC
• Disable
Figure 42.
Select subscription method:
1 Select DECT > System.
2 Select subscription method in the Subscriptions drop-down list.
3 Click "OK".
7.5.4 Select Tones
1 Select DECT > System.
2 Choose tones in the Tones drop-down list.
3 Click "OK".
7.5.5 Set Default Language
If the handset does not send language information to the system, this setting determine
which language that is displayed for some text messages (for example hung-up and
disconnected).
1 Select DECT > System.
2 Choose language in the Default Language drop-down list.
3 Click "OK".
7.5.6 Set Frequency Band
The IPBS/IPBL can operate in the following frequency bands:
• 1880 - 1900 MHz, Europe, Africa, Middle East, Australia, New Zeeland and Asia
• 1910 - 1930 MHz, South America
• 1920 - 1930 MHz, North America
Figure 43.
1 Select DECT > System.
2 Select frequency area in the Frequency drop-down list.
3 Click "OK".
4 Reset in order to make the changes take effect, see 7.12 Reset on page 60.

ASCOM IP-DECT Base Station Specifications

General

Brand	ASCOM
Model	IP-DECT Base Station
Category	Cordless Telephone
Language	English