ASCOM IP-DECT Base Station User Manual

TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
28
5 Select system user name and password, see 7.5.1 Change System Name and
Password on page 41.
6 Set the mode to Master, see Figure 45. on page 44.
7 Set frequency band, see 7.5.6 Set Frequency Band on page 42.
8 Select tones, see 7.5.4 Select Tones on page 42.
9 Enter gatekeeper IP address or ID, see 7.5.15 Configure Gatekeeper on page 45.
10 Set the master IP address to 127.0.0.1, see 7.5.16 Enter IP Address to the Master
and the Standby Master on page 45.
11 Perform a reset to restart the IPBS/IPBL in master mode, see 7.12 Reset on page 60.
If problem to access the master from a certain PC after the reset;
• Open a command window in windows by selecting Start > Run and enter
"cmd" in the Open: text field.
• Enter the following commands
arp -d (Delete the arp cache)
nbtstat -R (Empty the nbtstat cache)
• Restart the WEB browser.
12 Select supplementary services, see 7.5.13 Configure Supplementary Services on
page 44.
13 Assign PARI, see 7.5.17 PARI on page 45.
14 Enter SARI, see 7.5.18 SARI on page 46.
Note: In some SW versions SARI is not available and a licence is needed, see 7.1.3
Licence on page 32.
15 Enter IMS IP address, see 7.5.19 Configure Messaging on page 46.
16 Configure air synchronization, see 7.5.20 Configure Air Synchronization on page
46.
17 Enter the Time Server address, see 7.1.5 Configure the NTP Settings on page 34.
18 Reset in order to make the configuration changes take effect, see 7.12 Reset on
page 60.
6.4 Configure the Standby Master
It is recommended to have a standby master in the IP-DECT system. This section describes
how to configure a standby master. Each configuration step is briefly described in the step
list below, for more detailed information see the corresponding subsection in
7 Operation
on page 31.
1 Determine the address and access the GUI, see 6.2 Access the GUI on page 25.
2 Change the default password, see 6.2.2 Change the Default Password on page 27.
3 Set a static IP address and set DHCP to off, see7.2.2 Set a Static IP Address on page
37.
4 Enter system user name and password, this should be the same user name and
password as in the Master. See
7.5.1 Change System Name and Password on page
41.
5 Set the mode to standby master, see 7.5.14 Select Mode on page 44.
6 Enter gatekeeper address, see 7.5.15 Configure Gatekeeper on page 45.
7 Enter master IP address, see 7.5.16 Enter IP Address to the Master and the Standby
Master on page 45.

ASCOM IP-DECT Base Station Specifications

General

Brand	ASCOM
Model	IP-DECT Base Station
Category	Cordless Telephone
Language	English