ASCOM IP-DECT Base Station - Configure Supplementary Services; Select Mode

TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
44
Note: When exclusive is enabled for a coder it might be impossible to make calls outside
the IP-DECT system.
1 Select DECT > System.
2 Choose the applicable coder in the Coder drop-down list.
Note: The G726-32 coder is not supported by SIP.
3 Enter the sample time in milliseconds in the Frame text field.
4 Choose Exclusive enabled or disabled by checking/unchecking the Exclusive check
box.
5 Choose Silence Compression enabled or disabled by checking/unchecking the SC
check box.
6 Click "OK".
7.5.13 Configure Supplementary Services
The supplementary services determine how to handle a call if for example busy or not
answered by the user.
1 Select DECT > Suppl. Serv.
2 Mark the Enable check box to activate the following supplementary services.
Figure 44.
Note: To disable a specific service, mark the Disable check box in front.
3 Enter the Message Center Number in the Message Center No. field.
4 Click "OK".
5 Reset in order to make the changes take effect, see 7.12 Reset on page 60.
Figure 45.
Figure 25. Supplementary services
7.5.14 Select Mode
The IPBS/IPBL can operate in three different modes: master, strandby master and slave.
1 Select DECT > Master.