TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
57
7.10.3 Update the Boot File
1 Select Update > Boot.
2 Click "Browse..." and browse to the boot file.
3 Click "OK"
4 Reset in order to make the changes take effect, see 7.12 Reset on page 60.
7.10.4 Update the RFPs
This section only applies to the IPBL.
The firmware can be updated. Follow the steps below to update RFP. Download firmware
from the IP-DECT system provider.
In the RFP status list, information on connected RFPs are displayed.
1 Select Update > RFPs.
2 Click "Browse..." and browse to the RFP update file.
3 Click "Upload".
Figure 60.
Figure 30. Upgrade the RFP
4 Select "Immediate" or "Scheduled" update.
5 Mark "In sequence" check box to update the selected RFPs one by one.
6 Mark "When idle" check box to start the update when the RFP is idle.
7 Mark the applicable RFPs to be updated.
8 Click "Start" to upgrade the selected RFPs.
The RFP restarts after the upload is finished.
To Next Page
Loading...
Need help?
General
