ASCOM IP-DECT Base Station - Configure the Master

TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
27
Figure 33.
018
Figure 19. Determine the IP address
4 Enter http://xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx is the determined IP address) in
the browser address field to access the GUI.
5 After the first startup of the IPBS/IPBL the DHCP mode should be changed from
"automatic" to either "client" or "off", see
7.2.1 Set DHCP Mode on page 37.
6.2.2 Change the Default Password
1 Enter the IP address determined in 6.2.1 Determine the IP Address in the web
browser address field.
2 Select General > Admin.
3 Enter user name and password in the dialogue box.
Default user name is: admin.
Default password is: changeme.
4 Enter a user name in the User Name text field.
5 Enter a password in the Password text field. Repeat the password in the second text
field.
6 Click "OK".
6.3 Configure the Master
This section describes how to configure the Master. Each configuration step is briefly
described in the step list below. For more detailed information see the corresponding
subsection in
7 Operation on page 31.
1 Determine the address and access the GUI, see 6.2 Access the GUI on page 25.
2 Change the default password, see 6.2.2 Change the Default Password on page 27.
3 Configure LDAP user name and password, mark the Write Access check box, see
7.4.1 Configure LDAP Server on page 39.
4 Set a static IP address and set DHCP to off, see7.2.2 Set a Static IP Address on page
37.