TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
40
3 Enter a password in the Password text field.
4 Mark the Write Access check box.
5 Click "OK".
Figure 40.
Figure 23. Setting LDAP User Name and Password
7.4.2 Configure LDAP Replicator
The slaves are normally setup as LDAP replicators.
1 Select LDAP > Replicator.
2 Mark the Enable check-box.
3 Enter the IP address to the LDAP server in the Server text field.
4 Enter the IP address to the alternative LDAP server in the Alt. Server text field.
Note: If this IPBS/IPBL is configured as a standby LDAP server, enter "0.0.0.0" in the
Alt. Server text field.
5 Enter the LDAP User name and Password in the User and Password text fields.
6 Click "OK".
7.4.3 Check LDAP Replicator/Server status
1 Select LDAP.
2 Select Replicator/Status or Server/Status.
To Next Page
Loading...
