ASCOM IP-DECT Base Station User Manual

TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
52
7.7.2 Air Sync
This section only applies to the IPBS.
Air Sync status is displayed in the Device Overview > Air Sync menu. For explanation on
the information shown for the active and the alternative sync bearers, see the table below.
Figure 52.
RFPI Radio Fixed Part Identity is the Id number of the sync bearer.
Carrier The carrier used for air synchronization
Slot The slot used for air synchronization
Hop The number of hops from the sync master to the sync bearer
RSSI Received Signal Strength Indication
FER Frame Error Rate, a value between 0 and 100%. Should be
below 80% to be able to keep the synchronization.
7.7.3 RFPs
This section only applies to the IPBL.
Information about the DECT devices connected to the IPBL. For explanation on the
information, see the table below.
1 Select Device Overview > RFPs.
Figure 53.
Figure 27. Connected RFPs to the IPBL
2 Click the applicable port to open the RFP details pop-up window.

ASCOM IP-DECT Base Station Specifications

General

Brand	ASCOM
Model	IP-DECT Base Station
Category	Cordless Telephone
Language	English