TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
53
Figure 54.
Figure 28. RFP Details
Figure 55.
Port The port used in the IPBL.
Status Current status of the DECT base station connected to the IPBL.
Description A short description to help identify the DECT base station.
RFPI Identity number.
SW Version The current software version.
Hardware The hardware version.
Boot RFP boot version.
Connected Time The elapsed time since the RFP connected to the IPBL.
Cable Delay The delay caused by the cable.
Tx Error The number of transmitting errors.
Rx Error The number of receiving errors.
BER SC0 Bit Error Rate SC0. Normal value: 0.
SER SC1 Bit Error Rate SC1. Normal value: 0.
Note: If BER differs from 0, inspect the RFP cable.
3 The following actions are available:
• Click "OK" to save your settings and close the pop-up window.
• Click "Cancel" to close the pop-up window.
• Click "Refresh" to update the information.
• Click "Reset" to reset the RFP.
To Next Page
Loading...
Need help?
General
