TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
30
Configure the rest of the IPBS/IPBLs following the steps below:
Note: Uploading the same configuration to all slaves can only be done if the DHCP is set
to client.
1 Determine the address.
2 Select Update > Config and browse to the previously saved configuration. Click
"OK".
3 Reset in order to make the configuration changes take effect, see 7.12 Reset on
page 60.
4 Repeat step 1 to 3 for all Slaves.
6.6 Add Users
This section describes how to add users to the IP-DECT system. There are two ways to
register handsets:
• Using the handset to automatically associate the IPEI number to a user, see 6.6.1
Anonymous Registration on page 30.
• Entering the IPEI number of the handset manually, see 6.6.2 Individual Registration on
page 31.
6.6.1 Anonymous Registration
The IPEI, which is the unique identification number of the handset, can be assigned
automatically to a user. This is used to avoid having to enter the IPEI number manually.
Add users in the IP-DECT System
1 Under the Administration menu, select Users.
2 Click "New".
3 Enter the following information in the corresponding text fields, leave the IPEI and
the Auth. Code text fields empty:
• Long Name - The name of the user, need to be unique throughout the system.
This is the name presented in a called party´s display, unless this is configured in
the IP-PBX.
• Name - The user name.
• Number - The phone number extension, need to be unique throughout the
system.
• Password - Optional, is used for registration towards the gatekeeper.
• Display Text - Will be showed in the handset display when the phone is idle.
4 Click "OK".
5 Repeat step 2 to 4 for all users.
To Next Page
Loading...
Need help?
General
