TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
45
2 Select in the Mode drop-down list:
• ACTIVE, if this IPBS/IPBL is the Master.
• STANDBY, if this IPBS/IPBL is the Standby Master.
• OFF, if this IPBS/IPBL is a Slave.
3 Click "OK".
4 Reset in order to make the changes take effect, see 7.12 Reset on page 60.
7.5.15 Configure Gatekeeper
The Master need to know the address to the system gatekeeper.
1 Select DECT > Master.
2 Enter the address to the gatekeeper in the Gatekeeper IP address text field.
3 Enter the address to the alternative gatekeeper in the Alt-Gatekeeper IP address
text field.
Note: As an alternative to the Gatekeeper IP Address, the Gatekeeper ID can be
used.
4 In the drop-down list, select H.323 or SIP protocol.
5 Click "OK".
6 Reset in order to make the changes take effect, see 7.12 Reset on page 60.
7.5.16 Enter IP Address to the Master and the Standby Master
All IPBS/IPBLs need to know the IP address of the master and the standby master.
1 Select DECT > Radio.
2 Enter the address to the Master in the Master IP address text field. If this is the
Master, enter 127.0.0.1.
3 Enter the address to the standby master in the Alt-Master IP address text field. If
this is the standby master, enter 127.0.0.1.
4 Click "OK".
5 Reset in order to make the changes take effect, see 7.12 Reset on page 60.
7.5.17 PARI
The PARI is a part of the broadcast identity, which uniquely identifies an IPBS/IPBL. This
PARI is automatically assigned to each IPBS/IPBL in the system. But if more than one Ascom
IP-DECT system operates within the same coverage area, the systems need to have a
unique system identity in the PARI assigned in order to
differentiate the systems.
To see the occupied system IDs of other Ascom IP-DECT systems within the coverage area,
perform an RFP scan, see
7.9 Backup on page 56.
1 Select DECT > PARI.
2 Select a number between 1 and 36. If this is not done the IPBS/IPBL will randomly
select a number.
3 Click "OK".
4 Reset in order to make the changes take effect, see 7.12 Reset on page 60.
To Next Page
Loading...
