ASCOM IP-DECT Base Station User Manual

TD 92372GB
2007-06-18/ Ver. E
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
29
8 Select supplementary services, see 7.5.13 Configure Supplementary Services on
page 44.
9 Assign PARI, see 7.5.17 PARI on page 45.
10 Configure air synchronization, see 7.5.20 Configure Air Synchronization on page
46.
11 Enter IMS IP address, see 7.5.19 Configure Messaging on page 46.
12 Enter the Time Server address, see 7.1.5 Configure the NTP Settings on page 34.
13 Configure LDAP replicator, enter the IP address, user name and password to the
LDAP server. Alternative LDAP server must not be entered. Check the Enable check
box, see
7.4.2 Configure LDAP Replicator on page 40.
14 Reset in order to make the configuration changes take effect, see 7.12 Reset on
page 60.
If problem to access the standby master from a certain PC after the reset;
• Open a command window in windows by selecting Start > Run and enter
"cmd" in the Open: text field.
• Enter the following commands
arp -d (Delete the arp cache)
nbtstat -R (Empty the nbtstat cache)
• Restart the WEB browser.
6.5 Configure the Slave
This section describes how to configure the Slave. Each configuration step is briefly
described in the step list below, for more detailed information see the corresponding
subsection in
7 Operation on page 31.
Note: When one slave is configured, the configuration can be saved and uploaded to the
other slaves in the system.
1 Determine the address and access the GUI, see 6.2 Access the GUI on page 25.
2 Change the default password, see 6.2.2 Change the Default Password on page 27.
3 Set DHCP mode to "Client", see 7.2.3 Dynamic IP address via DHCP on page 38.
4 Configure LDAP replicator, enter the IP address, user name and password to the
LDAP server and the alternative LDAP server. Check the Enable check box, see
7.4.2
Configure LDAP Replicator on page 40.
5 Enter the system user name and password, this must be the same user name and
password as in the Master, see
7.1.1 Change User Name and Password on page 32.
With LDAP replication enabled, the password will be verified against the master. If
the password is wrong a single dot will appear in the text field.
6 Set the mode to Slave, see 7.5.14 Select Mode on page 44.
7 Enter master and standby master IP addresses, see 7.5.16 Enter IP Address to the
Master and the Standby Master on page 45.
8 Configure air synchronization, see 7.5.20 Configure Air Synchronization on page
46.
9 Enter the Time Server address, see 7.1.5 Configure the NTP Settings on page 34.
10 Reset in order to make the configuration changes take effect, see 7.12 Reset on
page 60.
11 Save the configuration of the Slave, see 7.9 Backup on page 56.

ASCOM IP-DECT Base Station Specifications

General

Brand	ASCOM
Model	IP-DECT Base Station
Category	Cordless Telephone
Language	English