ASIX Forte - Page 101

Page 101
12
Document history
Document
revision
Modifications made
2013-07-03
Newly created document
2013-12-18
Minor text corrections
2014-02-28
The NXP LPC2xxx family was added in the JTAG
Interface chapter
New command line parameter [/read]
2014-04-25
The STM8 family was added in the Connection
Examples chapter
2014-07-01
The ARM SWD interface was added in the
Connection Examples chapter
CE certificate was replaced by Declaration of
Conformity
2014-09-23
A note about reset of MCU ARM SWD was cleared.
Described new option - Show only the lowest byte of
word in ASCII
2014-11-21
Updated list of variables for up_dll.dll
2014-11-25
New settings of the UP program have been added.
2015-02-03
Added View/Console menu description.
Added description of PIC32MZ_BootProg variable.
Small text fixes.
2015-03-12
The name of item Delay for VDD switching on/off
has been changed
Added description of the checksum settings
2015-04-07
Updated description how to create SVF file for
Lattice.
2015-05-19
A chapter about forte.dll was added.
The C8051 and EFM8 C2 interface was added in the
Connection Examples chapter.
Definition of input voltage on pins was added.
Description of w=32 parameter for Windows
messages was added.
2015-08-05
Description of the programmer driver installation
has been changed.
Added new /getpartrev parameter.
Added new commandline errorcodes.
2015-09-21
Added description of the setting of the warning
when the loaded file is not aligned to a word size.
Fixed links.
2015-11-19
Added description of setting of the T pin during and
after programming.
2016-01-22
The serial numbers logging description has been
updated.
2016-03-08
Added description of the Display programmer form
function.
Added description of the setting which disables the
VPP before VCC warning.
2016-05-20
The PE description has been updated.
Added description of the start and end address for
the SPI Flash memories.
2016-08-10
Description of the HCSxxx connection has been
added.
2016-10-10
Added description of the /sn commandline
parameter and manual serial numbers description.
Added the commandline error code 9 description.
2016-12-15
Description of usage of the programmers at Linux
has been added.
2017-02-02
Added description of auto programming in the Mass
production window.
Added description of Keep manually modified data.
2017-02-10
The Linux driver instalation chapter has been
completed.
2017-03-13
A link to lin_ftd2xx has been added.
2017-03-23
Added description of /q1 commandline parameter.
2017-05-09
Added description of "Load last project on start-up"
option.