ASIX Forte - Page 7

Options ➙ Select programmer 63
Options ➙ Language selection... 63
Options ➙ Keyboard shortcuts... 63
Options ➙ Lock project 63
Help Menu 63
Help ➙ Help on program 63
Help ➙ List of supported devices 63
Help ➙ Check Internet for updates 63
Help ➙ ASIX website 63
Help ➙ About 63
64Programmer Settings Window5.5.4
FORTE Programmer Settings Window 64
Power supply from the programmer 64
In idle state 64
During programming 64
Reset 64
Settings Associated with RX600 Microcontrollers 64
▸ Protect with ID 64
▸ Allow using Configuration Clearing (erases
TM, ID)
64
▸ Baud Rate 64
Settings Associated with PIC Microcontrollers 64
▸ Programming method 64
▸ Use PE 64
Boot memory programming 64
Settings Associated with AVR and 8051
Microcontrollers
65
Oscillator frequency 65
Faster Programming with Slow Clock 65
Inverse Reset 65
Write RC osc Adjustment 65
HVP 65
Settings Associated with I2C Memory Chips 65
I2C Bus Speed 65
I2C Memory Address 65
Settings Associated with SPI Flash Chips 65
▸ Start address 65
▸ End address 65
PRESTO Programmer Settings Window 65
In idle state 65
During programming 66
Settings Associated with PIC Microcontrollers 66
MCLR Pin Control 66
Programming Method 66
Algorithm Programming 66
Use PE 66
Boot memory programming 66
Settings Associated with AVR and 8051
Microcontrollers
66
Oscillator Frequency 66
Faster Programming with Slow Clock 66
Inverse Reset 66
HVP 66
Settings Associated with I2C Memory Chips 67
I2C Bus Speed 67
I2C Memory Address 67
Settings Associated with SPI Flash Chips 67
▸ Start address 67
▸ End address 67
67HEX Editor Windows5.5.5
Selecting an Area 67
Code/Main Memory Editor 67
Data Memory (EEPROM) Editor 67
Configuration Memory Editor 67
Tips for Advanced Users 68
68
5.6 Running UP from Command Line
68List of Parameters5.6.1
Using a Project File 70
Examples of Use 70
File Opening 71
Device Programming 71