Asycube - Asyril SA
Programming Guide
73/83
HR_PLATFORM_VIBRATION_AMPL3
This value is written to the corresponding parameter in Section 4.2.
HR_PLATFORM_VIBRATION_FREQ3
This value is written to the corresponding parameter in Section 4.2.
HR_PLATFORM_VIBRATION_PHASE3
This value is written to the corresponding parameter in Section 4.2.
N/A for the Asycube 50 and 80.
HR_PLATFORM_VIBRATION_WAVEFORM3
This value is written to the corresponding parameter in Section 4.2.
HR_PLATFORM_VIBRATION_AMPL4
This value is written to the corresponding parameter in Section 4.2.
N/A for the Asycube 50 and 80.
HR_PLATFORM_VIBRATION_FREQ4
This value is written to the corresponding parameter in Section 4.2.
N/A for the Asycube 50 and 80.
HR_PLATFORM_VIBRATION_PHASE4
This value is written to the corresponding parameter in Section 4.2.
N/A for the Asycube 50 and 80.
HR_PLATFORM_VIBRATION_WAVEFORM4
This value is written to the corresponding parameter in Section 4.2.
N/A for the Asycube 50 and 80.
HR_PLATFORM_VIBRATION_DURATION0
This value is written to the corresponding parameter in Section 4.2.
HR_HOPPER_PARAMETERS_WRITE_TRIG
A rising edge trigs the write of the hopper vibration Holding Registers
HR_HOPPER_DIGITAL_OUTPUT1 (Address 1536+21) to
HR_HOPPER_DURATION0 (Address 1536+29) to the vibration parameters
(Section 4.3) for the identifier HR_HOPPER_PARAMETERS_WRITE_ID.
HR_HOPPER_PARAMETERS_WRITE_ID
The hopper vibration write trigged with
HR_HOPPER_PARAMETERS_WRITE_TRIG uses this Holding Register to save
the values at the given identifier, where 0 = ‘A’, 1 = ‘B’, …
HR_HOPPER_DIGITAL_OUTPUT1
This value is written to the corresponding parameter in Section 4.3.
To Next Page
Loading...
Need help?
General
