ATEQ AX6000 - Appendices: Safety Information; Operating Environment Safety Guidelines; Battery Charging Safety Precautions; Charger Safety Guidelines

Appendices
UM-30300D-U User manual AX 6000 Page 50 / 54
3. SAFETY INFORMATION
You must read and understand these safety instructions and warnings before using or
charging your lithium polymer batteries.
Operating environment
Remember to follow any special current regulations any area, and always switch off your device
when its use is prohibited or when it may cause interference or danger.
Use the device only in its normal operating positions.
Your device and its enhancements may contain small part. Keep them out of the reach of small
children.
About Charging
Use only the charger supplied with your device. Use of another type of charger will result in
malfunction and/or danger.
Use the specified battery in the equipment.
When the green LED turns off, the charge is complete.
About the Charger
Do not use the charger in a high moisture environment. Never touch the charger when your
hands or feet are wet.
Allow ventilation around the charger when using it. Do not cover the charger with paper or other
objects that will reduce cooling. Do not use the charger while it is inside a carrying case.
Connect the charger to a proper power source. The voltage requirements are found on the
product case and/or packaging.
Do not use the charger if the wires become damaged. Do not attempt to service the unit. There
are no serviceable parts inside. Replace the unit if it is damaged or exposed to excess moisture.
This charger is not a toy and should not be used by children or infirm persons without proper
training or supervision.
Do not use it as a power source.
Unplug it before attempting to service or clean it.
About the Battery
CAUTION: This unit contains an internal Lithium Polymer battery. The battery can burst or
explode, releasing hazardous chemicals. To reduce the risk of fire or burns, do not disassemble,
crush, pierce or dispose of the battery or the instrument in fire or water, do not short circuit or
short the contacts with a metal object.
Use a specified charger approved by the ATEQ manufacturer and supplied with the device.
Safety for Lithium Polymer battery use
NEVER leave the battery unattended during the charging process. Remove the battery on a
nonflammable surface. The battery must imperatively be placed on a non-flammable surface
during charging (ceramic platter or metal box).
Charge the Lithium Polymer battery ONLY with the charger provided.
NEVER use a Ni-MH (Nickel Metal Hydride) type battery charger to charge a Lithium Polymer
battery.