0940/CE-30300A-U
Tél. : +33 (0) 1 30 80 10 20 - Fax : +33 (0) 1 30 54 11 00
15, rue des Dames - 78340 LES CLAYES SOUS BOIS – France
www.ateq.com
DECLARATION OF CONFORMITY 00
We the undersigned, ATEQ, manufacturers of the ATEQ AX6000 REF : 303.00 declare that it
complies with the requirements of :
- LOW VOLTAGE Directive 73/23/CEE partially modified by Directive 93/68/CEE.
• standard EN 61 010-1 « Safety requirements for electrical equipment for measurement,
control and laboratory use »,
- EMC Directive 89/336/CEE partially modified by EMC Directive 92/31/CEE regarding :
• standard EN 61 326-1 « Electrical equipment for measurement, control and laboratory –
EMC requirements »,
9 standard EN 61 000-4-2 « Electrostatic discharge immunity tests »,
9 standard EN 61 000-4-3 « Radiated, radio-frequency, electromagnetic fields immunity
tests »,
9 standard EN 61000-4-6 « Immunity to conducted disturbances, induced by radio-
frequency fields »,
• standard EN 55 011 « Industrial, scientific and medica radio-frequency equipment - limits
et methods of measurements ».
9 standard EN 55 022 « Information technology equipment - limits and methods of
measurements »,
This enables ATEQ to guarantee that this instrument may be used in complete safety under the
following environmental conditions :
• indoor use,
• altitude up to 3000 metres,
• ambient operating temperature from 0°C to 50°C,
• 95 % maximum relative humidity without condensation,
• degree of pollution 2 as in CEI 664 (only non-conductive pollution, however a temporary
conductivity caused by condensation may occasionally be expected).
Chairman and Managing Director.
Mr. Jacques MOUCHET
To Next Page
Loading...
Need help?
General
