Chapter 5 - Accessories
UM-30300D-U User manual AX 6000 Page 43 / 54
Chapter 5
ACCESSORIES
1. ACCESSORIES
1.1. POWER SUPPLY
The power supply (fitted with the
instrument) converts a network voltage
(100 to 240 V AC) into a 24 V DC low
voltage supply. It has no power switch
and works as soon as it is plugged in.
It allows supplying the battery device
which manage itself the charge.
It is protected against surges and short
circuits via a thermal fuse (do not use
any other type of fuse).
Moreover, this supply can be plugged on all types of electrical plugs using different
removable pins.
The instrument is not designed to work during the battery charge.
1.2. BATTERY
The 12V DC 4400 mA/h battery with Lithium Polymer
(Li-Po) technology is integrated into a case of our
design.
The charge is doing with the power supply which is
directly plugged on the battery with a jack connector.
The battery is fitted with a LED which indicates the
charge state.
The battery charge time is less than 3 hours. The
charge can be carried out without the battery
installed on the instrument.
See the battery use conditions in the "Safety
precautions" paragraph in the appendices.
2 batteries are supplied with the instrument.
To Next Page
Loading...
