Chapter 4 – Functions of the instrument
UM-18400E-U ATEQ F580 User manual Page 93/168
2.2.1. 2) Setting the additional functions
9 Place the key in the ACCESS position .
9 Create a new program (refer to chapter 3 § 4.2. "Creation of a test program").
9 In the parameters list for this new program, confirm the FUNCTIONS parameter
(refer to chapter 3 § 4.4 "Parameter settings").
Only the functions which have been activated using the above method will
appear in the FUNCTIONS parameter.
2.2.1. 3) List of additional functions
a) Name
This function is used to customise a program, for example to name a program after the
part to be tested.
)Select the option and enter settings if necessary.
b) Chaining
This function enables several tests to be carried out by the instrument one after the
other. The instrument offers 8 program sequencing criteria.
The sequencing order can be edited; the choice of the following program is defined in
the parameters. By default the programs are sequenced according to their original
number P+1.
When an active program is sequenced
with another program, a "+" is
displayed behind the program number.
RUN
RUN PROGRAMME : Pr01+ LEAK TEST
SPECIAL CYCLE : Disabled
17:41:07 11/07/2002
Associated parameters to be set: NEXT PROGRAM, INTER-CYCLE (wait or coupling
time between two cycles). Chaining conditions: ALL RESULTS (under all result
conditions), PASS (part good), TEST FAIL (test part bad), REFERENCE FAIL
(reference part bad), ALARM, PRESSURE OUT (pressure error), REWORKABLE (parts
which can be repaired), CALIBRATION (calibration error).
)Select the option and enter settings if necessary.
To Next Page
Loading...