Chapter 4 – Functions of the instrument
UM-18400E-U ATEQ F580 User manual Page 94/168
c) International units
This function allows the operator to choose the particular unit system required for the
display of measurements and test results.
The different unit systems are: SI (International metric system, mm
3
/s, cm
3
/s, cm
3
/min,
cm
3
/h, ml/s, ml/min and ml/h) USA/SAE (Anglo-Saxon unit system, inch
3
/s, inch
3
/min,
inch
3
/h, ft
3
/s, ft
3
/min and ft3/h) CUSTOM measurement units.
If a personalised measurement unit is used, it is possible to attribute it a name. This
name will appear instead of the unit.
This name may be deleted in the
PARAMETERS / TEST TYPE menu.
PARAMETERS
UNITS : YES
REJECT UNITS : Cal-Pa
CAL DRIFT : 000 %
NAME :
Delete CAL name
16:29:12 02/10/2003
). Select the option and enter settings if necessary.
d) Filter
This function enables the slowing or the acceleration of the sampling speed, by carrying
out an average over the set measurement time; this will facilitate the reading of the
measurement.
) Select the option and enter settings if necessary.
e) Automatic connector
The automatic connector is a pneumatic control enabling the driving of an external logic
(pneumatic sealing connector). This control is activated at the start of the cycle and is
released at the end of the cycle (refer to “cycle end” diagram § 2.2.1.3) o).
If several programs are chained, the automatic connectors are activated according to
the times set as parameters in the first program and are deactivated according to the
times set as parameters in the last program in the chain.
They remain active throughout all cycles between the first and last program in the chain.
The various waiting times A are applied in the programs in between.
Associated parameters to be set: WAIT A, WAIT B.
)Select the option and enter settings if necessary.
To Next Page
Loading...