Chapter 4 – Functions of the instrument
UM-18400E-U ATEQ F580 User manual Page 100/168
•
Ballistic
This fill type enables fluctuation in the air pressure (filling parts with a high level of
deformation) and in particular allows the maximum fill limit to be exceeded without the
cycle stopping and an error message being displayed. However, in order to move to
stabilisation mode, the test pressure must be correct.
k) Blow mode
When this option is activated, the instrument fills the part to low pressure and this is
maintained between 2 cycles. This option is used when there is risk of increased damp
or dust when testing very dirty parts.
The blow pressure is set using a second regulator.
Note: this option is automatic and permanent, and is incompatible with the pre-fill type
function.
l) Fill regulator
This function provides a choice of which of two regulators to use for the fill (1 or 2).
m) Valve codes
The instrument has eight programmable electrical outputs (24V DC/100 mA maximum)
four of which may be reserved for optional marking (internal and external valve code 1)
and external dump (internal and external valve code 2). These outputs (one or more)
may be allocated to program numbers. They are generally used to select valves in a
cycle sequence. The required outputs may be activated for each program (see chapter
1 paragraph 4.3.12.
Associated parameters to be set: External 1, External 2, External 4, External 5, External
6, Internal 1, Internal 2.
) Select the option and enter settings if necessary.
C
123
C
456
EXTERNES
INTERNES
21
CC
J9
J2
1116
INTERNALS
EXTERNALS
To Next Page
Loading...