ATEQ F580 - Page 152

Chapter 4 Functions of the instrument
UM-18400E-U ATEQ F580 User manual Page 142/168
3.4.3. Sensor status
This menu enables the display the values in points measured by the sensors.
Select the SPE CYCLE menu. Then
select the SENSORS POINTS function.
CYCLE
RUN PROGRAM : Pr01 LEAK TEST
SPECIAL CYCLE : Disable
09:58:31 03/10/2003
CAL. P1 REG1
CAL. P1 REG2
CAL. PRESSURE 2
LEAK SENSOR CHECK
VALVE AUTO TEST
SENSORS POINTS
When the cycle is selected, press on
the CYCLE START key to launch the
calibration cycle.
The instrument carries out a dump and
displays the values in points of the
various sensors.
ATEQ F580
---- H01 ----
RUN/Pr:001
DIFF PIEZ1 PIEZ2
00285 -0132 00001
FILL
---- H02 ----
RUN/Pr:001
PRESS = 2.00 bar
READY
Stop the special cycle by pressing on
the END OF CYCLE key.
ATEQ F580
---- T01 ----
CYCLE/Pr:001
PRESS = 1.50 bar
PRET
---- T02 ----
CYCLE/Pr:001
PRESS = 2.00 bar
PRET