ATEQ F580 - Page 31

Chapter 1 – Installation of the instrument
UM-18400C-U ATEQ F580 User manual Page 21/168
4.3.11. J8 connector inputs planner
Start
End of
cycle
t
t
t
t
t
t
t
t
t
t
t
t tt
t
tt
t
t
Selection
head 3
Selection
prog 2
ATR
request
or CAL
or calib
ATR request…
on all the measurment
units (heads) in the
active programme of
each unit (or head)
Cycle on the program
N° 2 of all m. units
ATR request…
in the program N° 2 of
the m. unit N° 3
General start cycle in
the active program of
each m. unit (here the
unit N°3 stays in the
program N° 2)
Be carefull, all m.
units come back to
the program N°1
An impulse on any selection program
inputs, out of cycle, allows to activate
the program N°1 on all the m. units or
on the selected m. unit, in this case the
start cycle can be done only 0,5 s after
the end of the impulse.
¾ t = 0,5 sec minimum
¾ In the above example it be considered that all the inputs not listed are standing