ATEQ F580 - Page 32

Chapter 1 – Installation of the instrument
UM-18400E-U ATEQ F580 User manual Page 22/168
4.3.12. J9 and J10 connector
1 2 3 4 5 6 7 8 9 10111213141516
Depending on the required configuration, the boards may be a relay board, or an output
code board applied to any connector (J9 or J10) and each board may be assigned to
head number 1 or 2.
4.3.12. 1) Output codes board
Output codes / analogue outputs / temperature transducers :
PIN 1 COMMON (outputs 1, 2, 3) + 24 V DC
PIN 2 Output n°1, open collector
PIN 3 Output n°2, open collector
PIN 4 Output n°3, open collector
PIN 5 COMMON (outputs 4, 5, 6) + 24 V DC
PIN 6 Output n°4, open collector
PIN 7 Output n°5, open collector
PIN 8 Output n°6, open collector
OUTPUT CODES
24V DC 100mA Max
Outputs
PIN 9 12V Sensor power supply
PIN 10 0V Sensor power supply
PIN 11 SENSOR n°1 input
PIN 12 SENSOR n°2 input
TEMPERATURE
SENSORS
PIN 13 Analogue outputs n°1
PIN 14 COMMON (analogue output 1)
PIN 15 Analogue output n°2
PIN 16 COMMON (analogue output 2)
ANALOGUE
OUTPUTS
* Options.
24 V DC
8
7
6
5
4
3
2
1
0,1 A max
Charge / Load
Obligatory
diode for an
inductive load.