ATEQ F580 - Page 34

Chapter 1 – Installation of the instrument
UM-18400E-U ATEQ F580 User manual Page 24/168
4.3.12. 3) Activating a program from the J9 or J10 relay board
inputs 16 programs
To activate a program from the J9 or J10 connector inputs, you have to select pins 5 to
9 (one or more). Binary weight n + 1.
Pin combinations for program selection
Program
number
Pin 5
(Input 3)
Pin 6
(Input 4)
Pin 7
(Input 5)
Pin 8
(Input 6)
Pin 9
(Input 7)
1 0 0 0 0 0
2 1 0 0 0 0
3 0 1 0 0 0
4 1 1 0 0 0
5 0 0 1 0 0
6 1 0 1 0 0
7 0 1 1 0 0
8 1 1 1 0 0
9 0 0 0 1 0
10 1 0 0 1 0
11 0 1 0 1 0
12 1 1 0 1 0
13 0 0 1 1 0
14 1 0 1 1 0
15 0 1 1 1 0
16 1 1 1 1 0
4.3.12. 4) J9 or J10 Connectors (I/O inputs/outputs) programmable
input
Input 7 (pin 9) parameters can be set in the CONFIGURATION/CHANGE I/O menu.
The functions which can be programmed and are available on this input are all the
specials cycle:
9 Program selection.
9 Regulator 1 adjust request.
9 Regulator 2 adjust request.
9 Infinite fill request.
9 Piezo auto zero request.
9 Pass part sealed component learn request.
9 Fail part sealed component learn request.
9 Calibration check by volume request.
9 Custom unit learn request.
9 Custom unit check request.
9 ATR learning cycle request.
9 Volume calculation request.
Some possibilities appear only if the function is used.