Chapter 4 Functions of the instrument
UM-18400E-U ATEQ F580 User manual Page 68/168
1.4.5. "CURVE" display
This mode allows the live display of the test curves of a measurement unit. It is only
possible to display the curve of one measurement unit (Head) at a time. When a
measurement unit is selected it cancels the others automatically.
Curve display procedure:
In the "DISPLAY" menu, select the
"CURVE" menu, then select "YES" to
confirm the display of the unit.
DISPLAY
CENTRAL
STANDARD : NO
COMPACT : NO
RESULTS : NO
CURVE : YES
HEAD 01 : YES
HEAD 02 : NO
LED DISPLAY : NO
11:02:59 18/06/2002
Next, set the parameters for the
acquisition and display of the curve:
Program: to select the test program.
Sensor: to select the sensor.
Acquisition: to select the
measurement point acquisition speed
(normal, average, fast, turbo).
Mode: to chose the display of a single
cycle or continuously (for the "ONE
CYCLE" mode the display will only be
for the selected cycle, for the
"CONTINUOUS" mode, the curve will
be displayed and reset with each cycle
start.
DISPLAY
PROGRAM : Pr:01 LEAK TEST
SENSOR : TEST PRESSURE
ACQUISITION : NORMAL
MODE : ONE CYCLE
RECORDING ENABLED
11:03:39 18/06/2002
Once the parameters have been
entered, if we press on the "START"
key, then only the selected
measurement unit carries out its test
cycle start, the next time the "START"
key is pressed all the measurement
units carry out their test cycles.
To make all the measurement units
carry out their test cycle on demand,
press on the "C" key before pressing on
the "START" key
A curve is then displayed live. To the
right is an example of the pressure
sensor display.
ATEQ C540
3.750 bar
0.000 bar STEP x = 0.1 s
HEAD 01 : F5 :
Note: The thresholds are placed
automatically depending on the reject levels.
To Next Page
Loading...