82828282
Avertissements Installation
8282
Warnings Installation
shock. After the unit has been powered o, always wait 10
minutes before touching any electrical components. Static
electricity present in the human body can damage the com-
ponents. Discharge any static electricity from your body.
• Incorrect wiring can damage the system as a whole.
• If the voltage is too low or drops during start-up, the unit
may not start. In this case, please contact your energy
provider.
• Make sure that all cables are secure, that the wiring com-
plies with the applicable standards, and that no force is
being exerted on the terminal connections or cables.
REFRIGERANT LINE CONNECTION:
• All refrigerant circuits are subject to contamination by dust
and moisture. If contaminants enter the refrigerant cir-
cuit, they can compromise the reliability of the units. The
unit's connections and refrigerant circuits must be correctly
sealed. In the event of a subsequent fault and following
an expert inspection, the presence of moisture or foreign
objects in the compressor oil will systematically render the
warranty invalid.
• Check upon receipt that the refrigerant circuit unions and
plugs on the inside and outside unit are correctly positioned
and secured.
• Check that the refrigerant lines are correctly secured (plas-
tic plugs or pipe ends crimped and brazed). If the plugs
need to be removed during the operation (e.g. pipes cut),
ret them as soon as possible to prevent contamination of
the pipe.
To Next Page
Loading...
