When only performing a high flow purge procedure, a solvent suction pipe will not
be needed. When performing a solvent flush, fit a solvent suction pipe only when
ready to perform the DP clean procedure. For pump‑only systems, refer to
Figure: DP clean assembly for the pump only systems.
Figure 23 DP clean assembly for the pump only systems
1. Air filter 2. DP clean solvent flush fluid
connection
3. Inlet spool 4. Pneumatic valve inlet connection
5. Pneumatic regulator 6. Optional connection to the pneumatic
valve sensor
7. Pneumatic valve 8. Pneumatic valve electrical connection
1. Air filter 2. DP clean solvent flush fluid
connection
3. Inlet spool 4. Pneumatic valve inlet connection
5. Pneumatic regulator 6. Optional connection to the pneumatic
valve sensor
7. Pneumatic valve 8. Pneumatic valve electrical connection
6.16. Connecting the dry pumping system for serial
communications
6.16.1. MODBUS
MODBUS-RTU communication is available (AC D+ D-). Refer to Figure: Service
diagram for more information.
07/2021 - ©Atlas CopcoPage 1011950840208_A
Installation
To Next Page
Loading...
Need help?
General
