Atlas Copco DWS VSD+

▪ Chart (High resolution)
▪ Chart (Medium resolution)
▪ Chart (Low resolution)
4.4.2. Two and four value lines screens
This type of main screen shows the value of 2 or 4 parameters. Refer to Inputs
menu on page 37.
Figure
11 Typical Main screen (2 value lines)
1. Inlet pressure 2. Flow
3. Vacuum control, shutdown
*
4. Menu
5. ES
*
1. Inlet pressure 2. Flow
3. Vacuum control, shutdown
*
4. Menu
5. ES
*
* Text changes upon the pump's actual condition.
Figure 12 Typical Main screen (4 value lines)
1. Inlet Pressure 2. Flow
3. Element Body Temperature 4. Off, Shutdown*
5. Menu 6. Vacuum control, purge, preparing to
go online*
1. Inlet Pressure 2. Flow
3. Element Body Temperature 4. Off, Shutdown*
5. Menu 6. Vacuum control, purge, preparing to
go online*
* Text changes upon the pump's actual condition.
▪ Section A: shows the information about the pump operation (for example, the
inlet pressure or the temperature at the pump outlet). On the pumps with a
frequency converter, the load degree (flow given in %) of the maximum flow of
the actual inlet pressure.
Elektronikon® graphic controller
07/2021 - ©Atlas CopcoPage 341950840208_A